Are you looking to save some money on window replacement? If you know how to install vinyl windows properly, you can save some money on installation costs when the time to replace your vinyl windows comes.

The following article will give you a step-by-step guide on how to install vinyl window replacement in Mississauga.

How to Install Vinyl Windows

The following guide will instruct you on vinyl window installation. Consult your local windows company or contractor if you need advice on how to install vinyl siding around a window.

The first thing you need to do is to inspect your existing window frames. If they are warped, rotted, or damaged beyond repair, you might need to replace the window frame as well as the window. This is typically not a DIY job and will require the help of a professional contractor or windows installer.

Materials Needed:

  • Foam backer rod
  • Insulation
  • Shims
  • Acrylic Caulk

Required Tools:

  • Hammer
  • Hearing protection/Safety goggles
  • Cordless Drill
  • Level
  • Pry Bar
  • Tape Measure
  • Caulking Gun
  • Utility Knife

Step 1: Shop for Replacement Windows

Obviously, you need to purchase your replacement windows before you can install them. You should do some comparison shopping and go with the most reputable windows manufacturer.
Before you order your windows, you need to ensure that you are getting the correct size of windows, otherwise, this could cost you even more in the future. Check and double check the interior height and width of each and every window that needs replacing from top to sill as well as side to side.

Then you will need to decide if you wish to stick with single pane windows or upgrade to double or triple pane windows for enhanced insulation and energy efficiency.

Keep in mind that you will be installing the windows from inside your home. You should take extra care and time when installing the first window to ensure that you are doing it properly. After this, the process should go much quicker and smoother.

Step 2: Install the Window

Replacement windows will come already mounted in a new jamb that can be installed into the old frame using the following steps:

  1. Remove the inside stop. Keep it, as you can reuse it.
  2. Take out the lower window sash.
  3. Pull the parting stop out and dispose of it, as it will not be reused.
  4. Remove the top window sash.
  5. Remove the springs/sash liners (or you can pull out the weight by removing the sash cord pulleys and stuffing the weight pockets with insulation).
  6. Push the new window unit tightly in place against the outside stop.
  7. Screw the mounting screws on the sides.
  8. Caulk the outside.
  9. Install the trim pieces.
  10. Reinstall the inside stop (from step 1).

If you need further advice on how to install vinyl windows, contact the experts at Direct Pro Windows and Doors. We can offer professional step-by-step advice as well as help you choose the right windows for your home. Call today to get started with window and door replacement.